Topaz Signature Pad

If you would like to use a Topaz Signature pad to add a default signature to TraCS, you must have the software installed on the machine(s) where you will be doing signatures.

Steps are as follows:

1. Install the software that matches your model.

Links to the Topaz Signature Pad installers are below.

Plug-In Installers - https://www.sigpluspro.com/index.html

Bluetooth Installer (BT2 & BTB models) - https://www.sigpluspro.com/sigplus-bluetooth.html

2. Adjust settings for TraCS.

The settings in the TopazSignature.ini file may need to be adjusted in order for the unit to work with TraCS.

The file is here - C:\ProgramData\TraCS\Settings\DLL Settings

Settings for the models that are currently used by some of our TraCS agencies are below.

T-S460-BT2-R

T-S460-HSB-R

TF-S463-HSNB-R

[Signature]

'LCDSize 1=4X3 0=1X5 2=1X5 Simple

LCDSize=2

PromptImage4X3=\Settings\DLL Settings\SignaturePromptScreen.bmp

ConsentImage4X3=\Settings\DLL Settings\SignaturePromptScreenConsent.bmp

PromptImage1X5=\Settings\DLL Settings\SignaturePromptScreen1x5.bmp

ConsentImage1X5=\Settings\DLL Settings\SignaturePromptScreen1x5.bmp

3. Plug the unit into the computer and log into TraCS.

4. Follow the steps on this page to add the user signature.

Once you know the unit is working, we can push the settings file out to the agency if you would like.

If you need help, contact TraCS Support and we will be to assist with the set up.