Topaz Signature Pad
If you would like to use a Topaz Signature pad to add default signatures to TraCS, you must have the Topaz software installed on the machine(s) where you will be doing signatures and you must configure the unit to work with TraCS.
If you need help, contact TraCS Support and we will be happy to assist with the set up.
Steps are as follows:
1. Install the software that matches your Topaz model.
- Links to the Topaz Signature Pad installers are below.
- Plug-In Units - https://www.sigpluspro.com/index.html
- Bluetooth Units (BT2 & BTB models) - https://www.sigpluspro.com/sigplus-bluetooth.html
2. Adjust the TraCS settings.
- The settings in the TopazSignature.ini file may need to be adjusted in order for the unit to work with TraCS.
- The file is here - C:\ProgramData\TraCS\Settings\DLL Settings
- Settings for the models that are currently used by some of our TraCS agencies are below.
- If you have a different model, these settings may work for you. If they don't, contact us and we will assist with getting you set up.
- T-S460-BT2-R
- T-S460-HSB-R
- TF-S463-HSNB-R
[Signature]
'LCDSize 1=4X3 0=1X5 2=1X5 Simple
LCDSize=2
PromptImage4X3=\Settings\DLL Settings\SignaturePromptScreen.bmp
ConsentImage4X3=\Settings\DLL Settings\SignaturePromptScreenConsent.bmp
PromptImage1X5=\Settings\DLL Settings\SignaturePromptScreen1x5.bmp
ConsentImage1X5=\Settings\DLL Settings\SignaturePromptScreen1x5.bmp
3. Plug the unit into the computer and log into TraCS.
4. Follow the steps on this page to add the user signature.
5. Once you know it is working, we can push the settings file from the machine out to the agency. If you'd like it pushed out, contact us for next steps.